Your Engine Is Not in Our Stock List? We Have a Solution for That Too
Not every engine is permanently available from stock – particularly rarer variants or special specifications. That does not mean we cannot help you. On request we also carry out the complete overhaul of engines outside our standard range and recondition them professionally.
This applies especially to youngtimers and classic cars: over many years we have built up an extensive network of suppliers and specialists for sourcing rare spare parts.
How Does a Complete Overhaul Work?
So that you know exactly what happens to your engine, here are the individual steps explained in plain terms.
1. Dismantling and Cleaning
First we take the entire engine apart and thoroughly clean every single component. Only then can each part be assessed properly.
2.Checking for Wear
Every part is inspected: pistons, bearings, valves, cylinder head and more. Anything worn or damaged is replaced – no compromises.
3. Measuring and Renewing the Crank Drive
We measure the crank drive precisely and fit new bearing shells so the engine runs smoothly and quietly again. Where necessary, the crankshaft is also ground to undersize.
4. Machining the Cylinder Bores
Depending on their condition, we hone the cylinder liners or bore them to oversize. Matching new pistons or piston rings are then fitted.
5. Reconditioning the Cylinder Head
The cylinder head is checked for distortion and refaced if required. Valves are polished or replaced and carefully lapped in. Where necessary we also fit new valve seats so that the combustion chambers seal reliably again.
6. New Gaskets and Timing Drive
All gaskets as well as the timing chain or timing belt are renewed as standard. On timing belt engines we fit the complete belt kit on request.
7. Reassembly and Quality Control
Finally the engine is carefully reassembled. Each cylinder is pressure-tested individually for compression, the complete assembly is inspected visually and the valve timing is set and checked one last time.
What That Means for You
Even if your engine is not held in stock, you receive exactly the same careful overhaul as our standard units: hand-built in our master workshop, verified in two quality inspections and released only when everything is right.
Want your engine overhauled? Send us the engine code or VIN – we will check feasibility and prepare a quotation.

